KNW MATERIAL LAB / PELLETLAB G20 Desktop plastic pelletizing system KNW Material Lab technical overview — 2026-10-04 Available for quotation. Configuration and delivery lead time are reviewed for each inquiry. Workflow: single-screw extrusion > air cooling > strand cutting > collection. Application direction 1: pellet preparation for modified-material R&D using suitable pre-blended or pre-compounded formulations; review additives and filler loading for the proposed configuration. Application direction 2: assess sorted, shredded, compatible thermoplastic 3D-print scrap for re-melting and re-pelletizing into test pellets. Dry the prepared feedstock where its grade requires it. Sorting, size reduction and drying are separate steps, not G20 functions. Reused-pellet properties, process suitability and material-saving outcome depend on the actual waste stream and trial results. Output: approximately 0.1–2 kg/h, dependent on material and operating conditions. Reported pellet length: approximately 2.85–3 mm (not a full adjustment range or a diameter tolerance). Extruder: SJ16 single-screw extrusion module. Screw diameter: 16 mm; L/D: 16:1; maximum screw speed: 30 rpm. Maximum heating temperature: 450°C; heating zones: 3. Main motor power: 400 W; heating power: 320 W. Cooling: air cooling. Power supply: 220V or 110V / 50 Hz / single phase. Process direction: right to left; nominal line centre height: 400 mm. Machine dimensions: approximately 800 × 500 × 700 mm. Packed weight: approximately 70 kg, including wooden crate. Screw and barrel treatment: nitrided and polished. Material families for application review: ABS, PLA, PCL, PETG, PC, PEEK, PE, PP, TPU, TPE. Material suitability depends on grade, formulation and operating conditions. Filled formulations need application review. For quotation, include material grade, formulation, feedstock, required pellet diameter and length, target output and batch size, voltage and frequency, destination and project timing. Minimum batch, full size range and exact controller configuration are confirmed during the technical discussion. KUNWU Technology Co., Ltd. / KNW Material Lab https://knwmateriallab.com/products/pelletlab-g20/ Contact: Kris-Long Email: krislong245944202@163.com WhatsApp: +86 18774085576